How To Install Raymarine Fluxgate Compass Manual
.ST60 Compass Instrument Owner’s Handbook Document number: 81107-4 Date: 1 April 2004.Raymarine, ST60 and SeaTalk are trademarks of Raymarine Limited © Handbook contents copyright Raymarine Limited 2004.Handbook information To the best of our knowledge, the information in this handbook was correct when it went to press. However, Raymarine cannot accept liability for any inaccuracies or omissions it may contain. In addition, our policy of continuous product improvement may change specifications without notice.ST60 Compass Instrument Owner’s Handbook.Preface Contents Preface.i Important information.i Safety notices.i EMC conformance. I Handbook information.i Contents.iii Introduction.vii Data inputs.vii SeaTalk.viii Stand alone operation.viii Remote control.viii Mounting options.viii Parts supplied.ix Chapter 1: Operation.1 1.1 Getting started.ST60 Compass Instrument Owner’s Handbook Technical support.11 World wide web.11 Telephone help line.11 Help us to help you.11 Chapter 3: Installation.13 3.1 Planning your installation.13 Site requirements.13 Transducer.13 Instrument.14 EMC installation guidelines.15 Suppression ferrites.16.Preface Master/repeater status.
30 Leaving Intermediate calibration.31 4.4 Dealer calibration. 31 Calibration on/off.
32 Pointer response. 32 Heading display response.32 Boat show mode.
32 Factory defaults.32 Leaving Dealer calibration.33.ST60 Compass Instrument Owner’s Handbook. Course Over Ground (COG). Average Heading. The ST60 Compass instrument is constructed in a rugged weather proofed case.
It provides a sensitive and stable, combined analog and digital display, to deliver accurate information under even the most demanding conditions.SeaTalk network. Stand alone operation In Stand alone operation, the ST60 Compass instrument is connected only to the relevant transducer and does not display information from, or provide information to, any other instruments.Preface Parts supplied Unpack your ST60 instrument and check that the following items are present:. Item 1, ST60 Compass instrument with standard bezel. Item 2, Fixing studs (2). Item 3, Thumb nuts (2). Item 4, Gasket.ST60 Compass Instrument Owner’s Handbook COMPASS ST60 Steering Compass Instrument Owner's Handbook D4444-3.2. Carry out the linearization procedure.
Displayed information The information displayed on the ST60 Compass instrument is presented by means of a pointer and a digital display. The pointer gives a steering indication and the digital display shows the compass heading.Note: Use with Sea Talk autopilot If the ST60 Compass instrument forms part of a system which includes a Sea Talk autopilot operating in Auto, Vane or Track mode, the ST60 Compass instrument is forced to operate in Auto mode.Press the disp key to select COG. Provided you have GPS or similar positioning data on the SeaTalk system, the ST60 Compass instrument displays your course over the ground.
If such data is not available the digital display shows “-”.ST60 Compass Instrument Owner’s Handbook Switch on Normal display TRUE disp disp Note: Modes marked. rely on external data. Press Course Over Average Ground.
(COG) heading. for 3 seconds to reset average TRUE TRUE disp Using the disp key.Chapter 1: Operation Operation Locked mode operation To enter locked mode (see the illustration), press the lock key. The current heading is applied as the locked heading and flashes for 5 seconds, after which time the heading display shows either the locked heading or the current heading, depending on what has been set up during User Chapter 4, Calibration calibration, as the normal display in locked mode (see.The average course error is reset to zero whenever the locked heading is changed. Auto mode The auto mode is activated automatically when the ST60 Compass instrument is connected to a SeaTalk compatible autopilot.
How To Install Raymarine Fluxgate Compass Manual Diagram
LOCK Auto lock display.Man overboard/reciprocal course If the vessel is turned through 110° or more when the ST60 Compass Instrument is in lock mode, the ST60 Compass Instrument automatically locks to the reciprocal of the original course (180° from the original). The digital display shows the reciprocal course and the pointer shows the course error from the reciprocal course.ST60 Compass Instrument Owner’s Handbook.Chapter 2: Maintenance & Troubleshooting 2.1 Maintenance Servicing and safety. Raymarine equipment should be serviced only by authorized Raymarine ser- vice technicians. They will ensure that service procedures and replacement parts used will not affect performance. There are no user serviceable parts in any Raymarine product.All Raymarine products are subjected to comprehensive test and quality assurance programmes prior to packing and shipping.